It’s tough to tell though as like you say it’s hard to get clear pictures. Well it was just something that I thought warranted looking at closer as the discoloration looked like what I’d expect of a fried component. Testing the laser fire terminals for continuity, I measured zero continuity with laser idle and with laser firing commanded (the LED in the control panel turned red, but the laser did not turn on) I saw a post about measure continuity in la…ĭisconnect the large plug from the LaserBoard, and check continuity on the Laser Fire and Laser Gnd pins on the LaserBoard while the G1 command is running and the red “laser fire status” LED on the LaserBoard is on, there should be some continuity shown on the meter. The light in the laserboard is ON when it fire, but laser didn’t works. I tried different power in control panel and in lightburn. Software work good, but laser not, it trace the path but the laser not fire. Problem/ Question: I just got my LaserBoard this week. Machine: K40 nano m2 digital panel without ammeterįirmware: “I have a new board and I’m using whatever it came with” Laser not firing - new Cohesion3D Laserboard Hardware Installation
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |